1 install or remove the rubber boats before the first clean up the nearby hard object
2. The boat open and flat, the best temperature is 60 degrees Fahrenheit
3. Checkers valve spring rod to live off, counter-clockwise until Spring rod protruding
Note: The inflatable valve closed before you put live. Safety valve in the inflated automatically when too much exhaust to protect the boats
4
inflatable boat pump to each side of the inflatable tube on average, inflation is completed, security would live much of the gas discharge valve to avoid damage to hull cracks and waterproof protective film note: not full of gas before, do not install the bracket and Seats three. After installing the pedal half inflated necessary to facilitate the installation Note: Installing the pedal, the board to up
Climate and mode of operation will affect the pressure vessel, heat will rise and fall cold, such as long storage, the best
inflatable tents is that the gas discharge tips: Do not use rechargeable air pump inflatable tires, exhaust gas is too easy to damage due to hull cracks and waterproof membrane